top of page
This site was designed with the
.com
website builder. Create your website today.Start Now

PS4 - MOLDED SHOT GLASS

Assignment: Design and fabricate a molded component using a two- or three-part silicone mold. 

 

Limitations: Can use a maximum of 16 cubic inches of epoxy resin. Mold is a maximum of 27 cubic inches in volume. 

 

Fabrication: Mold - 2-part RTV silicone (MoldMax 40), created using pottery clay and foam board supports; shot glass - epoxy resin (EpoxACast 650)

 

Design Process:

bottom of page